Sell 【SHIP IN 24 HOURS】6-port SATA 3.0 PCI Express Expansion Card Adapter Card Compatible with SATA6G 3G 1.5G Hard Drives best price

Product selling point: 1. Comply with Serial SATA 3.0 specification and backward compatible with SATA2.0 and SATA1.0. 2. Comply with PCI-Express v2.0 specification and backward compatible with PCI-Express v1.0. 3. Support Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x and Gen 3i. 4. Supports communication speeds of 6.0 Gbps, 3.0 Gbps and 1.5 Gbps. 5. Support FIS based on port multiplier switching or command switching. 6. Compatible with SATA6G, 3G and 1.5G hard drives. 7. Support AHCI1.0 mode and IDE mode. Support Native Command Queuing (NCQ). Support hot swap. Support 4 SATA. Specification: Name: 6-port SATA3.0 expansion card Model: PCE6SAT-M01 Main control: applicable to Marvell 88SE92xx+109X Interface: PCI-E 1x, 2x, 4x, 8x, 16x Support system: suitable for WINXP / WIN7 / WIN8 / WIN10 / LINUX Bus interface: PCI-Express x1 slot Expansion interface: 6 SATA3.0 interfaces Product size: about 12*10*2cm/4.7*3.9*0.8inch The PCIE to SATA3.0 adapter card is used as follows: 1. The connection between the system disk and the PCIE to SATA3.0 adapter card and the solution: 1. The SATA interface mode of PCIE to SATA3.0 is AHCI mode. If you want to insert a system disk into our card, the premise is that your system disk must be installed in AHCI mode when installing the system on the motherboard. Otherwise, the system cannot be activated via our debit card. 2. If it is determined that the system disk SATA interface installed on the motherboard is in AHCI mode, you can directly insert the hard disk into our card, and then enter the motherboard BIOS to set the system disk as the first boot. 3. If the above two conditions are met, if the motherboard hard disk interface still fails to start, or restarts repeatedly, it may be caused by a conflict between the motherboard hard disk interface and our riser card. The solution is to enter the motherboard BIOS, set the motherboard's hard disk interface option to Disabled, and then save and restart the system. 2. Common disk and PCIE to SATA3.0 connection conditions and solutions: 1. When the system disk is inserted on the motherboard, the ordinary disk is inserted into the PCIE to SATA3.0 card, and only the adapter card information and the normal disk model need to be checked during startup. 2. If the conditions are met, or the system cannot be started, you must enter the motherboard BIOS and set the system disk to start for the first time. 3. Connection between system disk and ordinary disk and PCIE to SATA3.0 and solutions: 1. Prerequisite, if the system disk of the original motherboard installation system is tested in AHCI mode, the following methods can be used. If the system is installed in IDE mode, the system can only be reinstalled through PCIE to SATA3.0. 2. When the first condition is established and the motherboard BIOS still cannot be booted, set the system disk to boot for the first time.