Sell (Local Stock) GY-BMI160 6DOF 6-axis Rate Gyro Gravity Accelerometer Sensor Module IIC I2C SPI Comm Protocol gy bmi160 best price

(Local Stock) GY-BMI160 6DOF 6-axis Rate Gyro Gravity Accelerometer Sensor Module IIC I2C SPI Comm Protocol gy bmi160 BMI160 6-axis inertial motion sensor Product introduction The module uses Bosch\'s new BMI160 6-axis inertial motion sensor in a MEMS sensor package that integrates the top 16-bit 3-axis accelerometer with an ultra-low-power 3-axis gyroscope. The module can output acceleration data (acceleration values detected by the device in the X, Y, and Z directions) and gyroscope data (the speed at which the device rotates around the X, Y, and Z axes). When accelerometers and gyroscopes operate in full-speed mode, typical power consumption is as low as 950μA, which is only 50% or less of the power consumption of similar products on the market. Designed for Robotic application , Arduino , smartphones, tablets, and wearable devices, the Bosch BMI160 includes a built-in smart step counter algorithm that reads the number of steps directly through the registers. The built-in 3-axis acceleration and 3-axis gyroscope enable motion detection such as running and fitness. Module built-in LDO power management chip, VIN supports 3.2~6V wide voltage supply, also has a separate 3.3V interface, compatible with Arduino 3.3V and 5V controller direct drive. Application 1. Walking step 2. Acceleration detection 3. Inclination measurement 4. Display screen switching horizontal / vertical mode \ Technical specifications Working voltage: 3.2V~6V Current consumption: <1mA Interface mode: 2.54 pitch pin header Acceleration optional ruler: ±2g/±4g/±8g/±16g Gyro optional scale: ±125°/s, ±250°/s, ±500°/s, ±1000°/s, ±2000°/s Accelerometer zero drift: ±40mg Gyroscope zero drift: ±10°/s Programmable frequency: 25/32Hz~1600Hz 6D detection and positioning 16-bit data output Impact resistance: 10,000 gx 200μs 2 independent programmable interrupt generators Built-in 1024 byte FIFO Working temperature: -40 ° C ~ +85 ° C Calibration (A): ±2g: 16384LSB/g ±4g: 8192LSB/g ±8g: 4096LSB/g ±16g: 2048LSB/g (G): ±125°/s: 262.4 LSB/°/s ±250°/s: 131.2 LSB/°/s ±500°/s: 65.6 LSB/°/s ±1000°/s: 32.8 LSB/°/s ±2000°/s: 16.4 LSB/°/s Document : http://arduinolearning.com/code/arduino-bmi160-sensor-example.php